Clutch Parts

0.314" square end width 0.250" shaft diameter

This gearshift pin is oversized to fit gear shift levers with worn slots. The factory specifications for the original pin utilizes a 0.325" width for the square head. The oversized pin...

Retains gear shift lever into housing 0.254" thick 1.368" outside diameter 0.998" inside diameter

Plastic 10 splines 15/16" spline outside diameter  0.625" pilot diameter Must wrap pilot w/ tape to center the disc

6-1/2" Diameter  15/16" Spline I.D. 10 Splines

2-1/16" bottom inside diameter 11/16" hole diameter

6-1/2" diameter Do not start engine without checking clutch pressure plate finger clearance; failure to do so could damage the pressure plate and throw out bearing. Adjust clutch linkage...