Allis Chalmers Early Letter Series Tractors

0.747" body outside diameter 0.110" wire diameter 3.155" overall length 2 brake springs used per tractor / 1 per side Sold individually Model...

6-5/8" long 2 used per tractor; sold individually

Kit includes aluminum flat top pistons, rings, wrist pins and retaining clips. 2.395" overbore. Note: This kit also works for sealed power replacement # P1906-20. Other Application...

Carburetor Numbers TSX683 TSX882 TSX154,Serviceable TSX156,Serviceable TSX157,Serviceable TSX198,Serviceable TSX305,Serviceable TSX319,Serviceable TSX428,Serviceable...

Large exhaust hole 4" for muffler to fit through the hood Uses 70227240 muffler or 70233450 muffler 18 gauge (thicker than original which was only 20 gauge)...

Black powder coat. Bolt holes are 8" center to center.

As a clutch pilot bushing: B, C, CA, D10 (To Sn: 3501), D12 (To Sn: 3001), D14, [ D15, H3 (Gas/Lp) ], IB, As a power shift pilot bushing:...

Vinyl Decal set for Allis Chalmers Model WD. Mylar set is shown in photo due to the protective covering on the vinyl set. This set is identical with the exception that each decal is made of vinyl,...

12 Piece vinyl decal set for Allis Chalmers B. Black with Long A&S. 1939-1940. "B" model designation decal is included, though it was not used until 1953. Air Filter oil level decal...

To fit original tube, must sand approximately 0.005" off O.D. of bushing 1-3/8" outside diameter 3/4" inside diameter Nylon Model Note Equipment...

Dimensions: 1-1/4" inlet length 1-1/2" inlet O.D. 20-1/2" shell length 3-1/4" shell diameter O.D. 12-3/8" outlet length 1-1/2" outlet O.D....