Allis Chalmers Early Letter Series Tractors

Basic carb kit includes gaskets, float valve & throttle shaft.  mega-cross:    (1 to 5 of 5)                ...

Kit Includes: J-Hook 1/2" bolt 2.638" total length 1.212" total width Flat Washer Nut   0.300" opening 4 required per weight 8 used...

2.305" cap to cap 0.968" cap diameter D14     D15     D17     D19...

16 Piece Vinyl decal set in black for Allis Chalmers WD45. Mylar set is shown in photo due to the protective covering on the vinyl set. This set is identical with the exception that each decal is...

Steel Bare finish 6.080 overall length 1" wide 0.250" thick 2 holes = 0.375" O.D. 2 holes = 0.340" O.D. B    ...

Small exhaust hole 2-1/2" diameter Used with 70210081 muffler from the factory Can also use aftermarket 70227240 muffler 18 gauge (thicker than original which was...

For use with the carburetors listed below This basic carb repair kit includes: Throttle shaft Needle and Seat Float Lever Pin Choke and Throttle shaft seals...

Vinyl Black Decal Set for Allis Chalmers WD45 Diesel. Mylar set is shown in photo due to the protective covering on the vinyl set. This set is identical with the exception that each decal is made...

4-3/4" curved lens 1-1/2" stud length Can be installed on front or rear Electrical terminal is on the back NOT through the post as original

Carburetor Numbers TSV13 TSV15 TSV16 TSV17 TSV18 TSV21 TSV22 TSV24 TSV27 TSV35 TSV37 TSV45 TSV47 TSV48 TSV49 TSV50 TSV52 TSV53 TSV54

5.573" overall length 0.100" wire diameter 0.750" body diameter

Overbore 3-3/8" To 3-7/16"                                  Engine Parts >...