Allis Chalmers Early Letter Series Tractors

Check dimensions even if listed to fit your tractor. In most cases, these fit stamped steel center dishes. 9/16" x 18 UNF thread 1-1/8" long thread 7/8" hex head...

  Dim A (1)   11.43" O.D. Dim B (2)   10.645" I.D. Dim C (3)   .50" Thick Dim D...

Vinyl Decal set for Allis Chalmers Model WD. Mylar set is shown in photo due to the protective covering on the vinyl set. This set is identical with the exception that each decal is made of vinyl,...

23" overall length 1/4" tube outside diameter 1/4" 45 degree inverted flare nuts Stainless Steel 70910161 elbows not included, available by special order

Includes: New 9" woven clutch disc with 1-1/8" 10 splined hub 9" pressure plate Throwout bearing Pilot bearing Clutch lineup tool 2 Different...

As a clutch pilot bushing: B, C, CA, D10 (To Sn: 3501), D12 (To Sn: 3001), D14, [ D15, H3 (Gas/Lp) ], IB, As a power shift pilot bushing:...

This fender is more rounded than the original fenders on B, C and CA. Also on late applications, you will have to grind off the brackets. Same gauge, weight and material as original...

Mainframe Bracket for Newstyle Hitch Click here for photos of the factory!

Includes all gaskets required when replacing the cylinder head. Torque cylinder head bolts to  60 FT-LBS. Head gasket is 18" O/A length.

5" diameter 5/8" belt width 2-3/4" center to center across the bolt holes 7/16" bolt hole diameter The set screw is NOT included and must be purchased...

Please note the color of primer finish may vary 6-7/8" Long 3/4" Wide 0.104" Thick Model Note Equipment Information B SN: 101 &...