Allis Chalmers RC Tractor

0.004" thick Note: Kit is 1 set of 16 shims. Fits models with 116 and 125 c.i. engines.

Fits Allis Chalmers: B (sn 61221 & up), C (sn 18581 and up), CA, G, RC, WC (sn 74430 and up), WD, WD45, WF   May differ from image but fit will be the same.

We recognize that our engine kits are often more expensive than others.  There is a very good reason for that.  Quality.  Since we have been in the parts, repair, and...

3-5/8" overall length 0.030" diameter wire size Model Note Equipment Information B engine serial number: BE-51353 and up or CE-4661 and up...

For standard 1.937" rod journal. Priced and sold per journal; 4 used per engine. Measure before ordering

1/8" NPT male to 5/16" flare fitting for 5/16" fuel line Includes one 5/16" flare fuel line fitting

Kit includes: needle and 0.080" float valve seat idle adjust needle and spring float lever pin gaskets seals instructions Includes parts shown in picture...

2-3/8" to 2-7/16" slotted bolt holes 1-1/8" center hole Approximately 0.062" thick Check measurements before ordering.   Carburetor Numbers...

Crossed From:     AV105397    VAPORMATIC VOKA125    MEGA-CROSS  included in this kit:    (1 to 5 of 5)  ...

Core Rubber 20-15/16" Length 8-13/16" Width 1/16" Thick

For 0.010" (1.927") under size rod journal. Priced and sold per journal. Measure before ordering

Exactly like original All new material, including the steel spokes 15" diameter Tapered, keyed & stepped hub 11/16" - 3/4" steering shaft outside diameter 3 bare...