Engine Components

Threaded neck type can 4-27/32" length 3-17/32" outside diameter 2-3/4" - 4 thread

Copper 0.875" inside diameter 1.110" outside diameter 0.050" thick Fits: 190XT, B (Engine SN: 64501 & up), C, CA, D10, D12, D14, D15, D17, D19, D21, IB,...

7/8" - 18 UNF 1-1/8" Hex head Clear zinc finish

Fits listed tractor models with 201 & 226 cubic inch gas engines. 4 used per tractor; sold individually 1.945" tall 0.865" hole diameter Please measure before ordering...

D17 Gas / LP   WC Gas & LP models above engine SN: 72459 with 15 stud head   WD Gas / LP   WD45 Gas /...

4-13/16" length 1-1/2" tall 3-1/2" center to center mounting holes Rubberized cork

Measure before ordering 2.000" O.D. 1.500" I.D. 0.250" Wide Other Application Info Will not fit early Allis Chalmers B, C engines unless...

Cork Rubber 1/4" Thick 20-3/4" Long 6-1/4" Wide D17 Gas/LP with 201 or 226 cubic inch engines   WC Gas/LP with 201 or 226 cubic...

D17 GAS, LP   WC GAS   WD GAS, LP   WD45 GAS, LP   WF GAS  ...

Included in this kit are the valves, guides, springs, keepers (0.100" wide keeper groove) and stem seals. There kit is for valve seats with a 45 degree angle. NOTE: Does not...

Clear decal for oil filter. Red background is shown only for clarity. Decal is approx 4" x 4". Adds that finishing touch to your restoration work.

0.004" thick Note: Kit is 1 set of 12 shims. Fits models with 201 and early 226" gas, LP engines. Other Application Info Note: Kit is 1 set of 12...