Allis Chalmers D10 Tractor

This front wheel seal is made of steel and felt This Allis Chalmers front wheel seal measures 1.437" I.D. 2.563" OD. 0.586" wide Two used per...

Small Bearing: 0.750" I.D. 1.938" O.D. Large Bearing: 1.190" I.D. 2.500" O.D. Other Application Info 2 used...

4 used per tractor Sold individually 1.250" inside diameter 1.375" outside diameter 1.500" long Must be honed or reamed to size when installed

1.280" tall glass bow 3/8" pipe inlet (2) 1/8" pipe outlets   IB All Fuel, Using 2 Outlets   D10 Using 2 Outlets...

2.700" outside diameter 1.78" overall tab length 0.250" tab width Vented Includes gasket Chrome plated B Serviceable Only   IB...

13-1/8" overall length 1/4" tube O.D. 1/4" compression fittings Stainless Steel Note: You may have to trim to fit. Model Note Equipment...

3-5/8" overall length 0.030" diameter wire size Model Note Equipment Information B engine serial number: BE-51353 and up or CE-4661 and up...

Brass strainer screen insert for sediment bowl B (W/ SMALL BAIL TYPE BOWL) C (W/ SMALL BAIL TYPE BOWL) CA (W/ SMALL BAIL TYPE BOWL) D10 D12 D14 D15 (SN <9001) D17 (SN...

New Cork Sediment Bowl Gaskets (15 pk). 2" O.D. gaskets used with short bowl. Dim A (1)   2" O.D.   Allis-Chalmers...

2-3/8" to 2-7/16" slotted bolt holes 1-1/8" center hole Approximately 0.062" thick Check measurements before ordering.   Carburetor Numbers...

Fits the above listed Zenith carbs Make sure that your carburetor manufacturer number is in the list above; if your number is not in this list, this float is not the correct float for...

New, universal Zenith replacement. External appearance may vary from original carburetor. 2-5/16" to 2-3/8" CC stud holes (Because of the smaller diameter studs...