Allis Chalmers WF Tractor

For carburetors that measure 2-3/8" center to center bolt holes and 1-5/16" center hole     D14    ...

0.004" thick Note: Kit is 1 set of 12 shims. Fits models with 201 and early 226" gas, LP engines. Other Application Info Note: Kit is 1 set of 12...

Model Note Equipment Information D17 Gas, Diesel   WC     WD     WD45 Gas,...

Fits all listed models with 201 or 226 cubic inch gas or LP engines. Gasket is a cork finish. D17     WC     WD...

6.50" x 16" Triple rib 6 ply

Measure before ordering 2.000" O.D. 1.500" I.D. 0.250" Wide Other Application Info Will not fit early Allis Chalmers B, C engines unless...

This bushing is for the horizontal bolt hole 1.223" outside diameter at the largest point 0.597" hole inside diameter 0.724" overall length 2 to 4 used per shock...

Sealed bearing 0.984" inside diameter 2.047" outside diameter 0.590" wide Verify your tractor has a pilot bearing, not a bushing.  ...

For small bowl Marvel Schebler carbs The dimension from center of pin hinge to end of pontoon is 2.375" in length. Make sure that your carburetor manufacturer number is in the...

Shipping block under lever-square key  mega-cross:    (1 to 13 of 13)                 Replaces:  ...

Gasket Not Included But available Model Note Equipment Information WC     WD     WF  ...

4.25" wide x 16" diameter 3-3/8" pilot inside diameter 5 lug bolt holes 3" center to center lug bolt holes Recommended tire size is 5.50 x 16 to 6.50 x 16 ...