Allis Chalmers WD and WD45 Tractor

0.015" point gap This kit includes:  (1) Cover gasket # X5618, X5644, 90-5618, 94-5076A (1) Cover gasket # 6081 (1) Points # X5996, 90-X5996, 1-5008 (1) Condenser #...

6.50" x 16" Triple rib 6 ply

Cork Rubber 1/4" Thick 20-3/4" Long 6-1/4" Wide D17 Gas/LP with 201 or 226 cubic inch engines   WC Gas/LP with 201 or 226 cubic...

4.25" wide x 16" diameter 3-3/8" pilot inside diameter 5 lug bolt holes 3" center to center lug bolt holes Recommended tire size is 5.50 x 16 to 6.50 x 16 ...

1.140" free length 0.270" to 0.350" tapered O.D. 1 used per engine   B   used as an engine oil pump pressure regulating spring, 1 used...

Kit includes: choke shaft and throttle shaft needle and seat valve float lever pin miscellaneous plugs and screws throttle shaft seals and gaskets  ...

Sway Block for Allis Chalmers. Mounts on top of drawbar yoke. Does not fit D15 Series II or D17 Series III

For small bowl Marvel Schebler carbs The dimension from center of pin hinge to end of pontoon is 2.375" in length. Make sure that your carburetor manufacturer number is in the...

Model Note Equipment Information D17 Gas   WD45 Gas   170 Gas   175 Gas  ...

0.400" hole inside diameter Model Note Equipment Information B Used as a gear shift lever knob on SN: 120982 and up   IB...

1-3/4" inlet diameter 4" outside cap diameter 1-1/2" overall height Glossy black paint D15     WC    ...

WC     WD     WD45 Gas/LP   WF     Replacement Numbers...