Allis Chalmers WD and WD45 Tractor

D17 gas, LP with G201, G226 engines   WC Engine SN: 13665 and up; gas, LP with G201, G226 engines   WD gas, LP with G201, G226...

Includes metal retainers.   D17 Gas, LP   WC Elbow gaskets were never used.   WD Gas, LP   WD45...

Set of 6 Long Manifold studs, and 6 Brass Nuts. For WC, WD, WD45, and early D17 using 3/8" studs

Fits tractors with 12 volt negative ground system only. Check that your distributor number is listed in the application information. Will NOT fit IH horizontal...

Fits the above listed Zenith carbs Make sure that your carburetor manufacturer number is in the list above; if your number is not in this list, this float is not the correct float for...

Replaces      AT13847, AT16931 Spline Count      10 Spline Diameter      1.250"  mega-cross:    (1 to 8 of...

Shipping block under lever-square key  mega-cross:    (1 to 13 of 13)                 Replaces:  ...

Dash mounted Fits 2" diameter hole Face reads, 'Allis Chalmers' under range 75" lead length 5/8" - 18 UNF end with 1/2" NPT pipe bushing...

Fits Allis Chalmers: B (sn 61221 & up), C (sn 18581 and up), CA, G, RC, WC (sn 74430 and up), WD, WD45, WF   May differ from image but fit will be the same.

2.5" outside diameter Model Note Equipment Information D10     D12     WC  ...

Fits most oil bath air cleaners to replace the mesh in the existing air cleaner Approximately 3" wide x 78" long per bag Utility tractors require 2 bags / 2 elements...

Inlet = 2.275" I.D. Base O.D. of cap = 4.94" Diameter D17 Gas up to SN: 42000 and Diesel up to SN: 38963   WD45 Diesel  ...