Allis Chalmers WD and WD45 Tractor

There are 10 pieces in this kit. Includes filter O-ring WD both using Eaton belt driven power steering pump   WD45 both using Eaton belt driven...

3.135" overall length 0.595" outside diameter 0.081" wire diameter 2 used per tractor Sold individually Model Note...

This gearshift pin is oversized to fit gear shift levers with worn slots. The factory specifications for the original pin utilizes a 0.325" width for the square head. The oversized pin...

4" bore (3) 0.125" compression rings (1) 0.187" oil ring Measure old rings before ordering. Do not order by tractor model only. Due to the many different piston...

WC both engine SN: 84247 and up the following with cylinder head casting # U3001 (see SN break for WC) and AM3820 WC older will fit the...

2.305" cap to cap 0.968" cap diameter D14     D15     D17     D19...

0.314" square end width 0.250" shaft diameter

11.017" O/A length, 0.373" OD D17 with 201 CI, 226 CI gas/LP engines   WC with 201 CI, 226 CI gas/LP engines   WD with...

This is the lower right hand corner of the grille that is usually rusted out of your old original grille, so if you are looking to fix your old grille and you can weld (You must cut rusted...

Cork Rubber 25.625" Length 6.500" Width 0.250" Thick D17 Diesel   D19 Gas and diesel   WD45 Diesel...

We recognize that our engine kits are often more expensive than others.  There is a very good reaon for that.  Quality.  Since we have been in the parts, repair, and...

Stainless steel bezel Steel housing Fits 2" diameter hole Includes Allis Chalmers logo Threaded terminal type 60-0-60 range Use on tractors converted to 12 Volt electrical sytem...