Allis Chalmers WD and WD45 Tractor

Check measurement before ordering. 7/8" and 1" diameter shaft 0.750" diameter U-joint caps Includes: yokes, pins and grease fitting RC Must Redrill...

4 used per tractors Sold individually 2.363" O.D. 1.662" I.D. 0.093" Thick Model Note Equipment Information D10    ...

This is the lower right hand corner of the grille that is usually rusted out of your old original grille, so if you are looking to fix your old grille and you can weld (You must cut rusted...

4" bore (3) 0.125" compression rings (1) 0.187" oil ring Measure old rings before ordering. Do not order by tractor model only. Due to the many different piston...

3 piece set Model Note Equipment Information D17 gas, LP   WC gas   WD gas   WD45...

Includes all gaskets and crankshaft seals for a major engine overhaul. Other Application Info Will also fit early WC / WF with 12 stud head, but will...

3-1/4" overall length 2 used per tractor Sold individually D17 Up to SN: 42000   WD     WD45  ...

Model Note Equipment Information WC Gas   WD Gas   WD45 Gas, w/ 226" engine   WF...

WC both engine SN: 84247 and up the following with cylinder head casting # U3001 (see SN break for WC) and AM3820 WC older will fit the...

This water pump with double pulley is completely new, from the seal to the housing. It fits the Allis-Chalmers Tractor D17 (with diesel engine SN <119938 except SN 117087-117104) and WD45 (with...

•  Includes bearing cups.    mega-cross: (1 to 2 of 2)      ...

2-3/16" inside diameter Fits gasoline models only Other Application Info Also fits Allis Chalmers G226 Power Unit.   WD45...