Engine Components

Threaded neck type can 4-27/32" length 3-17/32" outside diameter 2-3/4" - 4 thread

Copper 0.875" inside diameter 1.110" outside diameter 0.050" thick Fits: 190XT, B (Engine SN: 64501 & up), C, CA, D10, D12, D14, D15, D17, D19, D21, IB,...

7/8" - 18 UNF 1-1/8" Hex head Clear zinc finish

Includes 2 O rings, 0.125" thick. Other Application Info Sold per cylinder. Order 4 for 4-cylinder engine. For sleeve with 0.093" sealing ring groove....

0.004" thick Note: Kit is 1 set of 12 shims. Fits models with 201 and early 226" gas, LP engines. Other Application Info Note: Kit is 1 set of 12...

D17 GAS, LP   WC GAS   WD GAS, LP   WD45 GAS, LP   WF GAS  ...

Measure before ordering 2.000" O.D. 1.500" I.D. 0.250" Wide Other Application Info Will not fit early Allis Chalmers B, C engines unless...

Fits listed tractor models with 201 & 226 cubic inch gas engines. 4 used per tractor; sold individually 1.945" tall 0.865" hole diameter Please measure before ordering...

4-13/16" length 1-1/2" tall 3-1/2" center to center mounting holes Rubberized cork

Included in this kit are the valves, guides, springs, keepers (0.100" wide keeper groove) and stem seals. There kit is for valve seats with a 45 degree angle. NOTE: Does not...

Cork Rubber 1/4" Thick 20-3/4" Long 6-1/4" Wide D17 Gas/LP with 201 or 226 cubic inch engines   WC Gas/LP with 201 or 226 cubic...

Measure before ordering 2.000" O.D. 1.500" I.D. 0.250" Wide Other Application Info Will not fit early Allis Chalmers B, C engines unless...