Fuel System

Fits the above listed Zenith carbs Make sure that your carburetor manufacturer number is in the list above; if your number is not in this list, this float is not the correct float for...

Kit includes: choke shaft and throttle shaft needle and seat valve float lever pin miscellaneous plugs and screws throttle shaft seals and gaskets  ...

For carburetors that measure 2-3/8" center to center bolt holes and 1-5/16" center hole     D14    ...

For large bowl Marvel Schebler carburetors Other Application Info Make sure to find your Marvel Schebler carb manufacturer number in the list below. If...

New, universal Zenith replacement. External appearance may vary from original carburetor. 2-5/16" to 2-3/8" CC stud holes (Because of the smaller diameter studs...

For small bowl Marvel Schebler carbs The dimension from center of pin hinge to end of pontoon is 2.375" in length. Make sure that your carburetor manufacturer number is in the...

6-7/8" overall length 1" coil diameter 0.125" wire diameter

Replacement Number Note 223893 Allis Chalmers 70223893 Allis Chalmers C66-47-50 Zenith     9707,Fits...

24" overall length 1/4" tube outside diameter 1/4" 45 degree inverted flare nuts 70910161 elbows not included

0.752" outside diameter 6-5/8" overall length 2 used per tractor Sold individually Model Note Equipment Information D17 up to SN: 42000...

Basic carb kit includes gaskets, float valve & throttle shaft.  mega-cross:    (1 to 5 of 5)                ...

23" overall length 1/4" tube outside diameter 1/4" 45 degree inverted flare nuts Stainless Steel 70910161 elbows not included, available by special order