Allis Chalmers D15 Tractor

Kit includes: needle and 0.080" float valve seat idle adjust needle and spring float lever pin gaskets seals instructions Includes parts shown in picture...

Fits the above listed Zenith carbs Make sure that your carburetor manufacturer number is in the list above; if your number is not in this list, this float is not the correct float for...

For small bowl Marvel Schebler carbs The dimension from center of pin hinge to end of pontoon is 2.375" in length. Make sure that your carburetor manufacturer number is in the...

This tachometer measures 3.340" housing outside diameter and 2.050" long. Model Note Equipment Information D15 Gas, SN: 6631 & up  ...

This D14 Allis Chalmers speedometer has a white face (background) including the ALLIS CHALMERS logo. 3.340" housing outside diameter 2.050" long Our AC...

47 inch inner cable length; keyway on one end, square on the other end Threaded ends are 5/8-18 x 7/8-18 Metal covered sheath. Measure before ordering. D14...

1.561" overall length, key = 0.095" width, 0.302" O.D. Made with 1144 stress proof steel. D10 Gas/LP   D12 Gas/LP  ...

3/4 - 20 pipe thread to 7/8 - 18. 1.413 Length. Zinc dichromate. 12L14 steel. Model Note Equipment Information D10     D12...

This dash mounted gauge features a bracket with studs (1/8" NPT thread) 'ALLIS CHALMERS' on the face Chrome bezel Fits 2" diameter hole Measures from 0 to 45...

Mounting gasket included Includes four (4) 1/4"-28 x 1/2" slotted cap screws  Fits in 1-5/8" hole Learn about the Steiner Difference This...

Dash mounted Fits 2" diameter hole Face reads, 'Allis Chalmers' under range 75" lead length 5/8" - 18 UNF end with 1/2" NPT pipe bushing...

Has 1/4" male flare end Made for 4-FJX fitting   CA     D10 Up to SN: 9199   D12 up to SN: 9167...