Allis Chalmers Early Letter Series Tractors

1.140" free length 0.270" to 0.350" tapered O.D. 1 used per engine   B   used as an engine oil pump pressure regulating spring, 1 used...

This bushing is for the horizontal bolt hole 1.223" outside diameter at the largest point 0.597" hole inside diameter 0.724" overall length 2 to 4 used per shock...

1.495" bore with keyway 2.850" wide 7.869" outside diameter Model Note Equipment Information D17 Up to SN: 42000  ...

12 Piece mylar decal set for Allis Chalmers B. Black with Long A&S. 1939-1940. "B" model designation decal is included, though it was not used until 1953. Air Filter oil level decal...

Undersize main journal size, 0.010" (2.240") Priced and sold as set for engine. Measure before ordering; warranty void if package has been opened.

Vinyl Decal set for Allis Chalmers Model WD. Mylar set is shown in photo due to the protective covering on the vinyl set. This set is identical with the exception that each decal is made of vinyl,...

2 used per tractor Sold individually I.D. 1.375" O.D. 2.720" WIidth 0.468"

For 2.000" standard main journal Includes thrust washers  Priced and sold as set for engin

Cork Rubber 25.625" Length 6.500" Width 0.250" Thick D17 Diesel   D19 Gas and diesel   WD45 Diesel...

Includes the integral spring steel clips Model Note Equipment Information B     IB     C  ...

Model Note Equipment Information B With 8 1/2" or 9" Clutch   C With 8 1/2" or 9" Clutch   CA...

For small bowl Marvel Schebler carbs The dimension from center of pin hinge to end of pontoon is 2.375" in length. Make sure that your carburetor manufacturer number is in the...